Trouble updating zone alarm

Enter [ master code ] [ code number ] [ new 4 digit code ] The [ code number ] is a single digit either 2, 3, 4, 5, or 6 Push to return to the Ready mode when you are finished.

trouble updating zone alarm-87

To arm in the "Stay" mode, enter your access code to arm the system, but do not exit the premises.

The system will arm in the "stay" mode automatically bypassing the interior zones.

The keypad will beep 3 3 times if the chime is being enabled and one long beep if it is being disabled.

Push to return to the Ready mode when you are finished. Up to 5 additional access codes (2 thru 6) may be added.

Push to return to the Ready mode when you are finished. Your system continuously monitors a number of possible trouble conditions.

If one of these conditions occur, the keypad will beep twice every 10 seconds and the keypad "Trouble" indicator will light.The system will recognize the occupants have left the premises and once the exit delay has expired, the system will be fully armed.STAY Arming This feature allows you to arm the perimeter zones while leaving the interior zones inactive so that you can remain on the premises while the system is armed.You may also use this code as a way to QUICK-ARM the system if you enter this code when the system is disarmed.Note that this code will only arm the system, you still need a valid access code to disarm it. Enter the premise thru a designated entry delay door.3., to provide a tone each time a door or window is opened or closed.

Tags: , ,